NFS Services Administrator's Guide (762805-001, March 2014)

To mount a CD-ROM device, follow these steps:
1. Log in as superuser.
2. Update the appropriate AutoFS map, as follows:
cdrom -fstype=hfs, ro :/dev/sr0
For mount devices, If the mount resource begins with a “ / ” , it must be preceded by a colon.
For instance in the above section, the CD-ROM device, /dev/sr0, is preceded by the colon.
Supported backends (Map Locations)
AutoFS maps can be located in the following:
• Files: Local files that store the AutoFS map information for that individual system. An example
of a map that can be kept on the local system is the master map. The AUTO_MASTER variable
in /etc/rc.config.d/nfsconf is set to the name of the master map. The default master
map name is /etc/auto_master.
NOTE: To modify the master map name, use the -f option of the automount command
and specify the filename. The automount command uses the specified file as the master
map.
• Network Information Service (NIS): A service that enables you to administer the configuration
of many hosts from a central location. Common configuration information, which otherwise
has to be maintained separately on each host in a network without NIS, can now be stored
and maintained in a central location and propagated to all the nodes in the network. For
more information on NIS, see NIS Administrator's Guide (5991–2187). To locate this
document, go to the HP-UX Networking docs page at: http://www.hp.com/go/
hpux-networking-docs. On this page, select HP-UX 11i v3 Networking Software.
• LDAP: A directory service that stores information, which is retrieved by clients throughout the
network. To simplify HP-UX system administration, the LDAP-UX Integration product centralizes
user, group, and network information management in an LDAP directory. For more information
on the LDAP-UX Integration product, see the LDAP-UX Client Services B.04.00 Administrator’s
Guide (J4269–90064) available at: HP Business Support Center.
To configure the system to use one of these backends, follow these steps:
1. Configure the /etc/nsswitch.conf file by modifying the automount entry.
This enables you to specify one or more data stores to look up information (autofs maps). You
can also specify the order in which these data sources are looked up. The backends can be
specified to look up AutoFS maps. For more information on configuring the /etc/
nsswitch.conf file, see nsswitch.conf(4)
2. Configure the AutoFS maps on the specified data store.
Enabling LDAP support for AutoFS
Before you enable LDAP support for AutoFS determine which schema shall be used for storing the
AutoFS maps. The LDAP administrator can provide this information. HP-UX supports the following
two options for schemas:
• older schema that uses nisMAP and nisObject objects to represent the maps
• new schema that uses automountMap and automount objects
To enable LDAP support for AutoFS using the older schema, follow these steps:
Supported backends (Map Locations) 55