Installing and Administering OSI Transport Services

18 Chapter 1

HP OTS/9000 Resources

HP-UX Manual Reference Pages

While installing, conﬁguring, or troubleshooting OTS/9000, you may

need to refer to any of the following online manual reference pages (man

pages) for useful HP-UX operating system or OTS commands. To display

a man page, include /opt/ots/man in your MANPATH shell variable,

then type the following at the system prompt:

man <command name>

• osiadmin(1M), the OSI Administration program, gives you access to

the various conﬁguration, administration, and diagnostic tools to

setup and maintain OTS/ 9000.

• osiconf(1M), and interactive conﬁguration tool, allows you to verify

and modify conﬁguration information between OTS and FTAM.

• osiconfchk(1M) allows you to verify the correctness of conﬁguration

ﬁles prior to actually starting the OSI stack.

• osidiag(1M) initializes all the FDDI network interfaces on a system

and connects to the FDDI network.

• osiping(1M) sends a CLNP echo request to speciﬁed network hosts for

testing and debugging. (Only versions of HP OTS/9000 at C.05.02 and

later respond to osiping.)

• osistart(1M) allows you to start OSI services, such as FTAM and

X.400.

• osistop(1M) allows you to stop OSI services, such as FTAM and X.400.

• otsaddes(1M) adds a single end system entry to the speciﬁed subnet.

• otsaddis(1M) adds a single intermediate system entry to the speciﬁed

subnetwork.

• otsaddnsap(1M) adds a local NSAP to OTS conﬁguration.

• otsaddroute(1M) adds a single route entry for the speciﬁed

subnetwork.

• otsdeles(1M) deletes the speciﬁed end system entry.

• otsdelis(1M) deletes the speciﬁed intermediate system entry.

• otsdelnsap(1M) deletes a local NSAP from OTS conﬁguration.