Installing and Administering OSI Transport Services

134 Chapter 6
HP OTS/9000 Configuration Files
About the Configuration Files
About the Configuration Files
The OTS/9000 configuration files are standard ASCII files. For a new
installation, they are copied from /opt/ots/newconfig to /etc/opt/ots/conf.
This is accomplished when swinstall runs during the installation. You
can reset the configuration to its original (installed) condition by copying
the needed files from opt/ots/newconfig. This erases prior configuration
and customization.
The following configuration files are used by the OTS product:
OTS Files
ots_subnets Local subnetworks parameters
ots_dests Destination System parameters
ots_routes Routing parameters
ots_parms Protocol layer parameters
ots_genrl Miscellaneous parameters
ap_user_app Local Address for APRI X.410 Mode Applications
(Reserved for future use.)
Related Files
local_app FTAM/MMS local application parameters
remote_app FTAM/MMS remote responders parameters
Related files are not necessary for the OTS product. They are only used
when the related product has been installed. You can change these files
using any text editor.
The following shows an example of the configuration file format.
##############################################################
# OTS Route Parameters #
# #
# Note: Changes made by editing this file will not take #
# effect until the OTS stack is restarted or #
# updated. #
##############################################################
#
#@(#) C.07.00