Installing and Administering OSI Transport Services

Chapter 5 123

Conﬁguring and Verifying HP OTS/9000

To Conﬁgure RFC1006

RFC1006 is conﬁgured using the osiadmin tool. HP OTS /9000 does not

have to be conﬁgured. TCP/IP and the appropriate links must already be

conﬁgured. You will need your local IP Address for step 5.

1. Type osiadmin to start the conﬁguration. The ﬁrst screen presented

to you is the osiadmin Main Menu.

2. Select “OTS” since the RFC1006 is part of the OTS product.

3. Select “Conﬁgure OSI over TCP (RFC1006)” from the OTS menu.

When the “Set Conﬁguration Mode” menu appears, accept the

defaults (restart mode) and Press “Done”. Press the space bar if a

warning message appears on the screen.

4. Select “Add...” from the RFC1006 Conﬁguration menu.

5. Enter an IP Address for your local system on the Add RFC1006

Subnetwork menu. Accept the defaults for other entries.

6. Press f4 to “Perform Task”. This completes the conﬁguration task.

7. Look at the OTS Conﬁguration ﬂowchart to determine the next task

you should perform.