Installing and Administering OSI Transport Services

112 Chapter 4
Installing HP OTS/9000
Installing HP OTS/9000 Software
2. Upgrade HP-UX 10.01 to the latest version. Also upgrade
applications to the latest versions; this includes upgrading OTS
C.05.02 to the latest version. Refer to “Installing and Upgrading HP
OTS/9000 from HP-UX 10.01” in this document.
Upgrade from HP-UX 9.x to 10.01
Use the Upgrading from HP-UX 9.x to 10.x manual as the guide to
upgrade HP-UX 9.x to 10.01. After you have upgraded HP-UX to 10.01,
upgrade HP OTS/9000 to the 10.01-compatible version (OTS version
C.05.02) using swinstall(1M). The 9.x to 10.01 upgrade of HP
OTS/9000 occurs when you install the 10.01-compatible version of HP
OTS/9000. Follow steps 1 through 10 described in “Installing HP
OTS/9000 Software” in this chapter to run swinstall and install and
upgrade OTS/9000.
The following actions are performed by the HP OTS/9000 control script
while running swinstall(1M):
1. All 9.x product files, except the configuration files are deleted from
their 9.x locations.
2. The 10.01 HP OTS/9000 product is installed on the system.
3. After the installation is complete, the product configuration files are
copied from their 9.x location (/etc/net/osi/conf) to their 10.x
location (/etc/opt/ots/conf). These files are then converted to the
format required for HP OTS/ 9000 which is compatible with HP-UX
10.01.
4. During the LAN product upgrade, the LAN interface names may be
modified. The HP OTS/9000 upgrade process will get the new
interface name and replace the old interface name with the new
interface name in the file /etc/opt/ots/ conf/ots_subnets. If problems
are encountered, while converting the HP- UX 9.x interface names to
the HP-UX 10.x interface names, an error message is printed in the
log file /var/adm/sw/swagent.log. If there is an error, the file
/etc/opt/ots/conf/ots_subnets may not be correct for the LAN
configuration on the HP-UX 10.01 system. You will have to make the
necessary corrections manually in the ots_subnets file before
starting HP OTS/9000.
The following line in the ots_subnets file may be modified during
the upgrade:
snet_if_name <lan interface name>