Installing and Administering OSI Transport Services

110 Chapter 4
Installing HP OTS/9000
Installing HP OTS/9000 Software
10.Activate the OK button on the Note Window to reboot. The user
interface disappears and the system reboots.
11.Once the system comes back up, log in as root and view the
/var/adm/sw/swagent.log and /var/adm/sw/swinstall.log
files to view any error or warning messages that may have occurred
during the installation.
12.If this is a new installation, go to the chapter “Configuring and
Verifying OTS/ 9000” in this manual.
13.Perform the verification steps described in the chapter “Configuring
and Verifying OTS/9000” in this manual. You are done when you can
successfully perform the verification steps.
Installing and Upgrading HP OTS/9000 from
HP-UX 10.01 or Later
You must upgrade the operating system to the latest version of HP-UX
before installing the latest version of HP OTS/9000. After you have
upgraded HP-UX, upgrade HP OTS/9000 from the 10.01-compatible
version (C.05.01 or C.05.02) by installing the latest version of the HP
OTS/9000 software onto the system using swinstall(1M).
Refer to “Installing HP OTS/9000 Software” in this document for OTS
installation instructions.
Installing and Upgrading HP OTS/9000 from
HP-UX 9.x
CAUTION If you intend to upgrade your HP-UX operating system from a 9.x
version, please note the following BEFORE continuing with the
installation/upgrade process:
In order to upgrade to the latest version of HP-UX, you must first
upgrade to HP-UX 10.01. During the upgrade from HP-UX 9.x to HP-UX
10.01, the /etc/netlinkrc file is transitioned to the appropriate
/etc/rc.config.d/* files. If you upgrade your operating system
before the rest of your networking products, you may receive a failure on
startup for the network (the HP-UX Start-up in progress list, the
Configure LAN interfaces item shown during system boot). This may be
due to an attempt to configure a non-existent link (one of your
networking products needs to be upgraded to the 10.01 version.)