Installing and Administering FTAM/9000

7
Preface
Purpose
This manual contains installation, configuration, and verification steps
for HP FTAM/9000, Hewlett-Packard's File Transfer, Access, and
Management product which enables you to manipulate local and remote
data files.
• Installation is the process of copying the software from the product
tape (magnetic or cartridge) to your system's disk. The installation
steps are in chapter 1, “Installing HP FTAM/9000.”
• Configuration is the process of customizing the product to reflect the
correct addresses and parameters that are required for your system.
The configuration information is in chapter 2, “Configuring HP
FTAM/9000.”
• Verification is the process of verifying that all of the configuration
information has been entered successfully. The verification
information is in chapter 3, “Verifying HP FTAM/9000.”
Audience
You should be the person who is responsible for installing product
software, configuring local and remote nodes, and verifying
configurations. You need to be able to issue node names, addresses, and
parameters that are unique to your network, or be able to obtain that
information.
Related Tasks
Before starting the tasks in this manual, you need to have installed,
configured, and verified the other parts of your “OSI stack” (OTS/9000
and the LAN/9000 link, the X.25/9000 link, and/or the FDDI/9000 link,
as applicable). “The HP OSI Series” section in the OSI Troubleshooting
Guide specifies what manuals you need to perform these tasks.
After you have completed the tasks in this manual, you will need to
perform interoperability testing as described in the OSI Troubleshooting
Guide. Troubleshooting information is also included in that manual.