Installing and Administering FTAM/9000

32 Chapter 2
Configuring HP FTAM/9000
HP FTAM/9000 Configuration
Figure 2-3 View/Modify FTAM Responder Screen
NOTE If you make configuration changes to the FTAM Responder, you need to
start HP FTAM for the changes to take effect. Refer to the last section of
this chapter for instructions.
To configure the FTAM Remote Responder
1. Select Remote Responders: Add ...
The Add Remote Responder screen shown below is displayed.
2. Enter the values from the FTAM Remote Responder worksheet.
3. Press Perform Task f4.
A pop-up screen is displayed which states Task completed.