HP-UX VLAN Administrator's Guide, February 2007

IMPORTANT: Use the Cancel button rather than the browser navigation buttons when
using HP SMH.
• Help buttons are available for all operations.
Navigating to VLANs
Use the following procedure to invoke HP SMH and navigate to the main VLAN configuration
page:
1. Enter the following:
# /usr/sbin/smh
Alternatively, to launch HP SMH from a browser window, enter:
http://name_of_system_to_administer:2301
If the DISPLAY environment variable is set, HP SMH opens in the default web browser. If
the DISPLAY environment variable is not set, HP SMH opens a TUI window.
NOTE: Most examples in this chapter use the GUI interface. One example of a TUI interface
is shown for reference in Figure 2-2 (page 32).
2. Select Tools (from the options tool bar at the top of the window).
3. Scroll down to the Network Interfaces Configuration box. Select Virtual LANs.
This takes you to the HP SMH Network Interfaces Configuration tool, main VLAN
configuration page. This page displays a table of all configured VLAN interfaces. If no VLAN
interfaces are configured on the system, the table is empty. When you select a VLAN interface,
all attributes of the interface are displayed. Figure 2-1 (page 31) shows an example of the
page displayed when an interface is selected.
The right side of the page displays available actions. The top portion of the page displays
global actions (available regardless of whether or not a specific VLAN is selected). Below
this, the page displays specific actions applicable to the selected VLAN interface.
30 Using HP SMH to Configure and Administer HP-UX VLANs