HP-UX LAN Administrator's Guide (Feburary 2007)
Table Of Contents
- About This Document
- 1 New for the HP-UX 11i v3 Release
- 2 Installing HP-UX LAN
- 3 Configuring HP-UX LAN Using SAM
- 4 Manually Installing and Configuring HP-UX LAN
- 5 Troubleshooting HP-UX LAN
- Troubleshooting Overview
- Troubleshooting Q & A
- LAN Interface Card Statistics
- 100Base-T Checklist
- Diagnostic Flowcharts
- Flowchart 1: Configuration Test
- Flowchart 2: Configuration Test continued
- Flowchart 3: Configuration Test continued
- Flowchart 4: Network Level Loopback Test
- Flowchart 5: Network Level Loopback Test continued
- Flowchart 6: Transport Level Loopback Test (using Internet Services)
- Flowchart 7: Link Level Loopback Test
- Flowchart 8: LAN Connections Test
- Flowchart 9: Gateway Remote Loopback Test
- Flowchart 10: Gateway Remote Loopback Test continued
- Flowchart 11: Subnet Test
- 6 LAN Resources
- 7 Network Addressing
- Overview of Network Addressing Schemes
- Networking Terminology
- Network Addresses and Node Names
- Internet Addresses
- Subnet Addresses
- Configuring Gateways on Fixed-Length Subnets
- Variable-Length Subnet Addressing
- Configuring Gateways on Variable-Length Subnets
- Configuring Gateways on Supernets
- IP Multicast Addresses
- Virtual IP (VIP) Addresses
- CIDR - Classless Inter-Domain Routing
- 8 LAN Device and Interface Terminology
Troubleshooting HP-UX LANDRAFT COPY
Diagnostic Flowcharts
Chapter 562
Flowchart 3: Configuration Test continued
Figure 5-5 Flowchart 3
3
I
J
D
NE
C
A
B
yes
no
G
H
F
K
L
M
yes
no
2
1
2
2
ifconfig
not found
Bad system
call
No such
interface
Check for
plumbing error
Any other
error message
Restore ifconfig
from media
Reconfigure
HP-UX kernel
to include
HP-UX LAN
Execute:
/sbin/init.d/net
.init start
Call HP
Find correct
interface
name
Execute:
netstat -in
Call HP
Is Hardware
State UP?
Ping
127.0.0.1?
Call HP
Execute: lanscan
or nwmgr
Execute: lanadmin
or nwmgr