HP-UX Internet Services Administrator's Guide (August 2003)
9
About This Document
This guide provides an overview of the Internet Services software and
describes how to install and configure it on your HP-UX 11i v2 operating
system. It is one of the five new manuals documenting the Internet
Services suite of products. See “Related Documentation” on page 11 for a
list of the other new Internet Services manuals. These manuals replace
the manual Installing and Administering Internet Services
(B2355-90685), which was shipped with previous releases of the
operating system.
This manual assumes that the HP-UX 11i v2 operating system software
and the appropriate files, scripts, and subsets are installed.
Intended Audience
This manual is intended for system and network administrators
responsible for configuring and maintaining the Internet Services
software on the HP-UX 11i v2 operating system. Administrators are
expected to have knowledge of operating system concepts, commands,
and the various routing protocols. It is also helpful to have knowledge of
Transmission Control Protocol/Internet Protocol (TCP/IP) networking
concepts and network configuration; this manual is not a TCP/IP
tutorial.
HP-UX Release Name and Release Identifier
Each HP-UX 11i release has an associated release name and release
identifier. The uname (1) command with the -r option returns the release
identifier. Table 1 shows the releases available for HP-UX 11i.
Table 1 HP-UX 11i Releases
Release
Identifier
Release Name
Supported Processor
Architecture
B.11.11 HP-UX 11i v1 PA-RISC
B.11.20 HP-UX 11i v1.5 Intel Itanium Processor Family
B.11.22 HP-UX 11i v1.6 Intel Itanium Processor Family