HP OSI Transport Services/9000 Release Notes

5
1. Support to multiple RK6 (RFC1006) NSAPs on a single system.
The NSAP can be created dynamically or added statically by specifying in
the ots_subnets config file.
RK6 is used to configure OTS over TCP connections.
2. The number of LAN CLNS subnets is increased to eight from a previous
limitation of five.
3. A flag OTSSTOP is added to the product. This feature can be controlled by
turning ‘on’ or ‘off’ the OTSSTOP flag in the /etc/rc.config.d/ots. By
default the flag is set to ‘on’.
Benefits
Upgrading to HP OTS/9000 version C.13.00 provides the following
benefits:
1. Support to multiple RK6 NSAPs on a single system.
When RK6 is able to listen on multiple ports, we can configure a new NSAP for
each port and start applications using those NSAPs.
2. The support for number of LAN CLNS subnets is increased to eight.
It is now possible to configure up to eight CLNS LAN subnets with OTS.
3. The OTSSTOP flag when set to ‘on’ will invoke the OTSSTOP script when the
system is shutting down. This feature can be controlled by turning ‘on’ or ‘off’
the OTSSTOP flag in the /etc/rc.config.d/ots.
4. Support for HP-UX version 11.31. If you wish to upgrade to HP-UX
version 11.31, you must also upgrade to HP OTS/9000 version C.13.00.
5. Updated documentation set with HP OTS/9000 version C.13.00.
Fixes
Numerous fixes were incorporated into this release of HP OSI Transport
Services/9000. See the section "Patches and Fixes in this Version"
for more information.
Note
The Advanced Communication Controller card (ACC/X.25) if supported on
HP-UX version 11.31, then it may be used with HP OTS/9000 version C.13.00.
Compatibility and Installation Requirements
Software Requirements
• HP-UX 11.31 operating system
If you are currently running an older version of HP-UX, you must