HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

1. (optional) If you are using In-Band Management, configure the IP management interface (if
you have not already done so).
HP-IB> enable
HP-IB# config
HP-IB(config)# interface mgmt-ether
HP-IB(config-if-mgmt-ethernet)#ip address 10.3.102.8. 255.255.0.0
HP-IB(config-if-mgmt-ethernet)#gateway 10.3.0.1
HP-IB(config-if-mgmt-ethernet)#no shutdown
HP-IB(config-if-mgmt-ethernet)# exit
HP-IB (config) # exit
2. In the privileged-execute mode, enter the copy command with the remote system and path
information.
The “remote system” must be the IP address of the TFTP server.
Syntax:
HP-IB> enable
HP-IB# copy tftp://<remote-system>/<filepath> <filesystem>:<filename>
HP-IB# copy tftp://@10.10.20.78/tftp dir/HP-AB291A-Release-1.1.3hp-build020.img
image:HP-AB291A-Release-1.1.3hp-build020.img
*****************operation completed successfully
HP-IB#
3. (Optional) View the images by using the dir image command.
HP-IB# dir image
======================================================================
Existing Boot-Images on System
======================================================================
slot date-created size file-name
----------------------------------------------------------------------
1 Mon Aug 11 22:41:19 2003 29830309 HP-AB291A-Release-1.1.3hp-build020.img
4. Install a New Image
After downloading the image file to the chassis controller, it must be installed. The install
command installs the specified image file into the system.
To install an image file:
88 Administration and Management