HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

mod is the program module in side the application.
lev is the verbosity of the trace information returned.
val is a decimal or hex value.
card is the slot number of the card being traced.
Command Modes: Global-configuration mode.
Privilege Level: General read-write user.
Usage Guidelines: The number of applications and modules may change between releases.
The numbers assigned to applications and modules may also change. Check application and
module number assignments using CLI help (i.e.,?) before executing this command, as shown
in the example below.
Examples:
HP-IB(config)# trace app ?
app <1-25>
app numbers:
APP_ID_CLI = 1
APP_ID_OSPF = 2
APP_ID_RIP = 3
…
…
APP_ID_IP_AGENT = 22
APP_ID_FIB_AGENT = 23
APP_ID_KERNEL = 24
APP_ID_CARD_AGENT = 25
APP_ID_SM = 26
HP-IB(config)# trace app 4 module 36 level very-verbose flowmask 0x12 card 2
Defaults: This command has no defaults.
Related Commands: “show trace” (page 174)
type
Synopsis: The type command defines the type of gateway or switch cluster connection being
configured.
Syntax: type type
Table B-76 type Command Argument
DescriptionArgument
type may be one of the following:
• controllerIb12port4x (90-only controller)
• ib12port4x (12-port 4X InfiniBand)
type
Command Modes: Configuration Card (config-card) mode.
Privilege Level: Unrestricted or card-specific read-write user.
Usage Guidelines: The card type must be specified before it may be enabled.
Examples:
HP-IB Example:HP-IB(config-card-2)# type en4port1G
Defaults: InfiniBand switch cluster connection type does not have to be specified because it is
automatically detected and configured when the system boots up.
Related Commands: “shutdown” (page 208)
“show card” (page 136)
212 Switch Command Line Interface