HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

HP-IB(config)# ntp server-one 10.0.3.110
HP-IB(config)# ntp server-two 10.0.3.111
HP-IB(config)# ntp server-three 10.0.3.112
Defaults: This command has no defaults.
Related Commands: “clock” (page 192)
“show clock” (page 139)
“show ntp” (page 170)
ping
Synopsis: Use the ping command to verify if a host can be reached from the system.
Syntax: ping dest
dest is the IP address or DNS name of the host, port, or expansion module you wish to ping.
Command Modes: User-execute and privileged-execute modes.
Privilege Level: General read-only user.
Usage Guidelines: You may ping between connected Ethernet and InfiniBand hosts, to the
system Ethernet Management port, gateway ports, and expansion modules (some gateway
functions are not supported by HP InfiniBand).
The reply packet tells you if the host received the ping and the amount of time it took to return
the packet.
A DNS server must be configured on the network for you to use DNS names.
Examples:
HP-IB# ping 10.3.102.24
Sending 5 ICMP Echoes to 10.3.102.24, 56 data bytes
!!!!!
Success rate is 100 percent (5/5)
round-trip min/avg/max = 0.000000/0.000000/0.000000 ms
HP-IB#
Defaults: This command has no defaults.
Related Commands: “hostname” (page 200)
radius-server
Synopsis: The radius-server command configures a radius-server.
Syntax: radius-server {host ip address}
Table B-73 radius-server Syntax Descriptions
DescriptionSyntax
Enter this keyword before the ip address of the radius-server.
host
Enter the ip address of the radius-server that is to be configured.
ip address
Command Modes: Privileged-execute mode.
Privilege Level: General read-write user.
Usage Guidelines: None.
Examples:
HP-IB> enable
HP-IB# config
HP-IB(config)# radius-server host 10.5.0.100
Defaults: This command has no defaults.
Related Commands: “clock” (page 192)
“snmp-server” (page 209)
Administrative Commands 207