HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

Table B-70 install Command Argument Descriptions
DescriptionArgument
Specifies the file resides in the image file-system.image
The name of the image file to install.file
Image files must reside in the image file-system and the file name must have the .img extension.
Command Modes: Privileged-execute mode.
Privilege Level: Unrestricted read-write user.
Usage Guidelines: After downloading the image file to the chassis controller, it must be
installed. The CLI install command performs everything necessary to install a new system-image
to flash disk. It automatically installs all necessary firmware and component images. Once
installed, the administrator must reinitialize the chassis using the newly installed system-image.
Run the boot-config command to specify the new system-image to use to initialize the chassis
when it boots up.
Only cards with an oper-status of up are updated. If a card is down when you run install, or a
card is added after running install, bring up the card and run install again. Specify the same
image file. If the image is already installed on a card, that card is skipped. Run the boot-config
command again so that all cards know to boot from the same system-image.
Examples:
HP-IB# install image:HP-AB291A-Release-1.1.3hp-build020.img Proceed with install? [yes(default) | no]
************************* operation completed successfully
Defaults: This command has no defaults.
Related Commands: “boot-config” (page 190)
“card” (page 192)
“show boot-config” (page 135)
“show card” (page 136)
interface
Synopsis: The interface command is used to enter a sub-command mode in which to
configure and InfiniBand interface cards, as well as chassis management connections.
Syntax: interface {type}
The interface sub-commands are listed in the table below.
Table B-71 interface Command Keywords
DescriptionKeyword
Enters interface mgmt-ib submode.
Configures the InfiniBand interface. See “InfiniBand Commands” (page 182) for a
description of InfiniBand configuration commands.
ib
Enters interface mgmt-ethernet submode.
The interface mgmt-ethernet command is used to enable and configure the IP addresses
for the port and gateway of the out-of-band Ethernet port used to administer the system
chassis.
Configures the out-of-band Ethernet management port used to administer the chassis.
See “interface” (page 201)
mgmt-ethernet
Configures in-band InfiniBand management port used to administer the chassis. See
“interface mgmt-ib” (page 203)
mgmt-ib
Command Modes: Privileged-execute mode.
Privilege Level: Unrestricted read-write user.
Administrative Commands 201