HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

Table B-54 Administrative Commands (continued)
DescriptionCommand
Used to leave the current mode for the previous mode or the user-execute mode.
See “exit” (page 197)
exit
Use to enable or disable ftp-services.
See “ftp-server enable” (page 197)
ftp-server enable
Gateway functions are not supported by HP InfiniBandgateway
Describes the types of help information available and ways to display specific
command-line information.
See “help” (page 199)
help
Shows command history. See “history” (page 199)
history
Assigns a name to the system. See “hostname” (page 200)
hostname
Installs a downloaded system-image to the appropriate locations. See “install” (page 200)
install
Used to enter a sub-command mode in which to configure InfiniBand interface cards, as
well as chassis management connections. See “interface” (page 201)
interface
Enables and configures the IP addresses for the port and gateway of the out-of-band
Ethernet port, which is used to administer the chassis (some gateway functions are not
supported by HP InfiniBand). See “interface mgmt-ethernet” (page 202)
interface
mgmt-ethernet
Used to enable and configure the IP addresses for the virtual port and gateway on the
InfiniBand fabric (some gateway functions are not supported by HP InfiniBand). See
“interface mgmt-ib” (page 203)
interface mgmt-ib
Configures the IP address and subnet mask for a virtual in-band InfiniBand port. See “ip
” (page 203)
ip
Used to assign a human-readable identifier to the system chassis. See “location” (page 204)
location
Used to change user identity during a CLI session. See “login” (page 205)
login
Configures active log.
See “logging” (page 205)
logging
Ends the current CLI session. See “logout” (page 205)
logout
Displays text data on the terminal screen for a stored log or configuration file. See “more”
(page 206)
more
Negate a command, or set its default.
no
Specifies the NTP servers to use to set and synchronize the system clock. See “ntp”
(page 206)
ntp
Verifies if a host can be reached from the system. See “ping” (page 207)
ping
Configures a radius-server. See “radius-server” (page 207)
radius server
Reboots the chassis. See “reload” (page 208)
reload
Enables or disables a specific interface card in the system chassis or the InfiniBand
Management Interface. See “shutdown” (page 208)
shutdown
Allows you set contact, location, and SNMP trap receiver information. See “snmp-server”
(page 209)
snmp-server
Use to enable or disable access to telnet services. See “telnet” (page 210)
telnet
Sets the number of lines displayed at one time by commands like more so that data does
not scroll quickly out of view. See “telnet” (page 210)
terminal length
Administrative Commands 189