HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

local routes are automatically created when you assign an IP address to a system card or port.
Some gateway functions are not supported by HP InfiniBand..
Examples:
HP-IB# configure
HP-IB(config)# ip route 192.168.3.0 255.255.255.0 10.10.1.0
Defaults: The default is an empty string.
Related Commands: “show ip” (page 168)
InfiniBand Commands
This chapter describes InfiniBand CLI configuration commands, which are used to administer
the system chassis.
The commands described here cover are all the InfiniBand-related commands, with the exception
of IPoIB commands. The IPoIB commands are covered in “IP Commands” (page 177).
The commands described in this chapter are listed in the table below, and described in alphabetic
order. Not all commands are available to users with limited privileges. Users with limited access
privileges can only display and use a subset of the commands displayed in this section.
The commands are broken-up into two different types:
• InfiniBand Subnet Management Configuration Commands
• InfiniBand Interface Configuration Commands
Table B-45 InfiniBand Commands
DescriptionCommand
Assigns static ARP addresses to InfiniBand interface ports. See “arp ib”
(page 177)
arp ib
Assigns static ARP addresses to InfiniBand interface ports. See “clear
ib arp-cache” (page 178)
clear ib
Used to administer the Subnet Managers for the switch fabric. See “ib
sm subnet-prefix” (page 182)
ib sm subnet
prefix
Used to configure the Subnet-Management Agent (SMA) node strings
for channel adapters. See “ib-agent channel-adapter” (page 185)
channel adapter
ib-agent
used to configure the Subnet-Management Agent (SMA) node strings
for internal switches. See “ib-agent switch” (page 185)
switch
Use to exit the current mode. See “exit” (page 197)exit
interface ib
Configure the IB virtual gateway. See “gateway” (page 198)gateway
Shows command help. See “help” (page 199)help
Shows command history. See “history” (page 199)history
Enables/Disables link-traps. See “link-trap ” (page 186)link-trap
Assigns names to FC interface cards. See “name” (page 187)name
Negate a command, or set its default.no
Enables or disables interface cards. See “shutdown” (page 187)shutdown
ib sm subnet-prefix
Synopsis: The ib sm subnet-prefix command is used to administer the subnet managers
for the switch fabric. This includes creating Partitions and adding members to those Partitions.
Syntax: ib sm subnet-prefix guid [priority priority] [sm-key sm-key]
[response-timeout timeout] sweep-interval interval]
182 Switch Command Line Interface