HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

“snmp-server” (page 209)
“ntp” (page 206)
“hostname” (page 200)
“ip name-server-one” (page 180)
“ip name-server-two” (page 181)
show terminal
Synopsis: The show terminal command shows the terminal parameters and configurations,
such as time-outs and maximum allowable command length.
Syntax: show terminal
Command Modes: User-execute and privileged-execute modes.
Privilege Level: General read-only user.
Usage Guidelines: This command is intended primarily for program debug under the direction
of Support personnel.
The number of applications and modules may change between releases. The numbers assigned
to applications and modules may also change. Check application and module number assignments
using CLI help (i.e.,?) for entering command arguments.
Examples:
HP-IB# show terminal
Console is enabled
Connection host address is 10.10.253.128
Length: 25 lines, Width: 80 columns
Timeouts: enabled, Value: 15 minutes
Session limit is set to 3
History is enabled, history size is 30
Maximum command length is 512 characters
Maximum login attempts is 5
Defaults: This command has no defaults.
Related Commands: “telnet” (page 210)
“terminal time-out” (page 211)
show trace
Synopsis: The show trace command tracks the system program modules called by a system
application for a specific interface card.
Syntax: show trace {app appInt [module modInt] [card cardInt]}
The syntax is described in the table below:
Table B-36 show trace Command Syntax Descriptions
DescriptionSyntax
Specify a system program application.
appInt is an integer between 1 and n, where n is an undetermined number that changes
between releases. appInt is the number of the internal application to trace.
app appInt
Indicates a module of the specified application. modInt is an integer between 0 and n, where
n is an undetermined number that changes between releases. modInt the number of the
program module in the application to trace.
module modInt
Corresponds to a slot in the chassis. cardInt is an integer between 1 and 2 (for the InfiniBand
Switch).
card cardInt
Command Modes: User-execute and privileged-execute modes.
Privilege Level: General read-only user.
174 Switch Command Line Interface