HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

show snmp
Synopsis: The show snmp command lists the SNMP receivers for switch link-traps, as well
as contact and location information.
Syntax: show snmp
Command Modes: User-execute and privileged-execute modes.
Privilege Level: Unrestricted read-write user.
Usage Guidelines: None.
Examples:
HP-IB# show snmp
============================================================================
SNMP Information
============================================================================
contact : [e-mail]
location : 3000 Hanover Street, Palo Alto, CA 94304
============================================================================
Trap Receivers
============================================================================
ipaddr version community
----------------------------------------------------------------------------
10.3.0.111 v2c public
HP-IB#
Defaults: This command has no defaults.
Related Commands: “location” (page 204)
“snmp-server” (page 209)
show system-services
Synopsis: The show system-services command shows all system services, such as FTP,
and Syslog.
Syntax: show system-services
Command Modes: User-execute and privileged-execute modes.
Privilege Level: Unrestricted read-write user.
Usage Guidelines: None.
Examples:
HP-IB# show system-services
================================================================================
System Services
================================================================================
ftp service : disabled
telnet service : enabled
syslog server : 0.0.0.0
================================================================================
NTP Information
================================================================================
date : 09/30/03
time : 09:57:19
server-one : 0.0.0.0
server-two : 0.0.0.0
server-three : 0.0.0.0
================================================================================
Host Information
================================================================================
name-server-one : 0.0.0.0
name-server-two : 0.0.0.0
domain-name :
Defaults: This command has no defaults.
Related Commands: “radius-server” (page 207)
Show Commands 173