HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

Mgmt-InfiniBand Information
===============================================================
descr : Inband Management Port
admin-status : up
ip-addr : 192.168.2.200
mask : 255.255.255.0
gateway-addr : 0.0.0.0
HP-IB#
Defaults: This command has no defaults.
Related Commands: “interface mgmt-ib” (page 203)
show interface mgmt-serial
Synopsis: The show interface mgmt-serial command displays the configuration of
the Serial-Console port on the system controller card.
Syntax: show interface mgmt-serial
This command takes no card or port designation.
Command Modes: User-execute and privileged-execute modes.
Privilege Level: General read-only user.
Usage Guidelines: The Serial-Console port is the initial connection point with the system
chassis and is used to configure the Ethernet Management and Management-InfiniBand ports.
This port must be configured and a management station attached before any interaction with
the system chassis is possible.
The CLI always defaults to port 1 on the active controller card.
Examples:
HP-IB# show interface mgmt-serial
===============================================================
Mgmt-Serial Information
===============================================================
baud-rate : 9600
data-bits : 8
stop-bits : 1
parity : off
HP-IB#
Defaults: This command has no defaults.
Related Commands: “show interface mgmt-ethernet” (page 167)
“show interface mgmt-ib” (page 167)
show ip
Synopsis: The show ip command is used to display global IP configuration data.
Syntax: show ip address-table
show ip ip-over-ib-mtu
show ip route
The syntax is described in the table below:
168 Switch Command Line Interface