HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

Table B-31 show interface ib Output Descriptions (continued)
DescriptionField
Indicates if the port is physically ready for configuration and use. The value of this field may be up
or down. If this field is down but the admin-status is up, check that the InfiniBand interface card is
securely seated in the slot and a cable is attached between the port and the target InfiniBand host.
oper-status
Indicates if connection link errors are to be captured and sent to trap recipients. The value may be
either enabled or disabled. This field is set by the config interface ib link-trap command.
link-trap
The administrative (admin) status, speed, and connection-type reflect the values you had assigned.
The operational (oper) status, speed, and connection-type reflect the values derived from the
physical hardware and its connections. This allows you to verify your configuration settings
against the actual hardware. The admin/oper pairs do not have to match for you to use the card.
However, if there is a mismatch, the oper value is used.
Examples: The following example shows the output of the show interface ib command without
the sma sub-command or statistics keyword.
HP-IB# show interface ib 15/1
===============================================================
InfiniBand Interface Info
==============================================================
port : 15/1
name : 15/1
type : ib4xTX
desc : 15/1 (961)
last-change : none
mtu : 4096
admin-status : up
oper-status : down
oper-speed : unknown
oper-duplex : unknown
link-trap : enabledHP-IB#
The following example shows the output of the show interface ib command with the statistics
keyword.
HP-IB# show interface gate 4 statistics
===============================================================
InfiniBand Interface Statistics
===============================================================
gateway : 4
name : 4/0 (256)
in-octets : 0
in-ucast-pkts : 0
in-multicast-pkts : 0
in-broadcast-pkts : 0
in-NUcast-pkts : 0
in-discards : 0
in-errors : 0
in-unknown-protos : 0
out-octets : 0
out-ucast-pkts : 0
out-NUcast-pkts : 0
out-multicast-pkts : 0
out-broadcast-pkts : 0
out-discards : 0
out-errors : 0
out-QLen : 0
HP-IB#
Defaults: This command has no defaults.
Related Commands: “interface ib” (page 186)
“ib-agent switch” (page 185)
164 Switch Command Line Interface