HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

def-mcast-pri-port : 255
def-mcast-NP-port : 255
life-time-value : 11
port-state-change : 0
lids-per-port : 0
partition-enf-cap : 64
Defaults: This command has no defaults.
Related Commands: “ib sm subnet-prefix” (page 182)
“show ib sm configuration” (page 141)
“show ib-agent switch” (page 156)
show interface ib
Synopsis: The show interface ib command displays the IP parameters and statistics for
ports on InfiniBand interface cards.
Syntax: show interface ibcard/port | all [sma args] [statistics]
The syntax is described in the table below:
Table B-30 show interface ib Command Syntax Descriptions
DescriptionSyntax
Refers to an individual card#/port# pair, a range of cards/ports, a list of cards/ports, or the keyword
all.
card/port
Use instead of entering individual card#/port# pair, or a range of cards/ports
all
The sma sub-command displays the attributes and table data for subnet management agents that
access InfiniBand ports. For an explanation of the sma sub-command, see “show interface ib sma”
on page 102.
sma args
The statistics keyword displays network statistics for the InfiniBand port on the interface card. The
information displayed is octets, unicast and multicast packets, discarded packets, protocol errors,
etc.
statistics
Command Modes: User-execute and privileged-execute modes.
Privilege Level: InfiniBand read-only user.
Usage Guidelines: Without the optional sma sub-command or statistics keyword, the show
interface ib command displays general information about the InfiniBand interface port, such as
its administrative status, its operational speed and status, and duplex mode.
The output fields of the show interface ib command are described in the table below.
Table B-31 show interface ib Output Descriptions
DescriptionField
Identifies the InfiniBand interface card and port. The format is card#/port#.port
User assigned name. If no name is assigned, the port name is displayed instead. This field is set by
the config interface ib name command.
name
Identifies the type of the InfiniBand card. Supported cards are ib1xTX, ib1xFX, ib4xTX, and ib4xFX.
This field is set by the config card type command.
type
Text description of the InfiniBand port. The default is the port identifier in the form slot#/card#.desc
Time at which the InfiniBand port configuration was last changed.last-change
Maximum Transmission Unit for the InfiniBand port. Used to configure the MTU size of IP network
traffic.
mtu
Indicates if you have enabled the port for configuration and use. The value of this field may be up
or down. The default is down. The field is set by the config interface ib shutdown command.
admin-status
Show Commands 163