HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

Table B-17 show ib sm port Command Field Descriptions (continued)
DescriptionField
Threshold at which ICRC, VCRC, FCCRC, and all physical errors result in an entry into the BAD
PACKET or BAD PACKET DISCARD states of the local packet receiver. See section 7.12.2, Error
Recovery Procedures, “InfiniBand® Architecture, Vol. 1, Release 1.0”, for more information.
local-phy-error
Threshold at which the count of buffer overruns, across consecutive flow-control update periods,
result in an overrun error. A possible cause of such errors is when an earlier packet has physical
errors and the buffers are not immediately reclaimed.
local-overrun-error
Examples:
HP-IB# show ib sm port subnet-prefix
fe:80:00:00:00:00:00:00
===============================================================
Subnet Management Ports
===============================================================
subnet-prefix : fe:80:00:00:00:00:00:00
node-guid : 00:05:ad:00:00:00:13:17
if-index : 1
mkey : 00:00:00:00:00:00:00:00
gid-prefix : fe:80:00:00:00:00:00:00
lid : 14
master-sm-lid : 1
cap-mask : 00:10:02:48
diag-code : 00:00
mkey-lease-period : 0
link-width-enabled : 3
link-width-supported : 3
link-width-active : 2
link-speed-supported : 1
state : active
phy-state : linkup
link-down-def-state : polling
mkey-prot-bits : 0
lmc : 0
link-speed-active : 1
link-speed-enabled : 1
neighbor-mtu : 2048
master-sm-SL : 0
VL-cap : vl0-vl7
VL-high-limit : 0
VL-arb-high-cap : 8
VL-arb-low-cap : 8
mtu-cap : 2048
local-overrun-error : 0…
The following example displays the ports of a node in summary form.
HP-IB# show ib sm port subnet-prefix fe:80:00:00:00:00:00:00 node-guid
00:05:ad:00:00:00:13:7f summary
============================================================================
Subnet Manager Port Summary
============================================================================
subnet-prefix node-guid if-index lid state
----------------------------------------------------------------------------
fe:80:00:00:00:00:00:00 00:05:ad:00:00:00:13:7f 1 0 active
fe:80:00:00:00:00:00:00 00:05:ad:00:00:00:13:7f 4 0 active
fe:80:00:00:00:00:00:00 00:05:ad:00:00:00:13:7f 5 0 active
fe:80:00:00:00:00:00:00 00:05:ad:00:00:00:13:7f 6 0 active
fe:80:00:00:00:00:00:00 00:05:ad:00:00:00:13:7f 9 0 active
HP-IB#
Defaults: This command has no defaults.
150 Switch Command Line Interface