HP Fabric Clustering System HP-UX Administrator's Guide, March 2008

================================================================================
Backplane Seeprom
================================================================================
base-mac-addr chassis-id chassis-guid
--------------------------------------------------------------------------------
0:d:9d:fe:1a:2e 0xd9dfffffe1a2e 0xd9dfffffe1a2e
================================================================================
Backplane Seeprom
================================================================================
product pca pca fru
serial-number serial-number number number
--------------------------------------------------------------------------------
US2043000060 C2042700040 95-00026-01-B3 AB399-62001
Defaults: This command has no defaults.
Related Commands: “show boot-config” (page 135)
“show card-inventory” (page 138)
show boot-config
Synopsis: The show boot-config command lists the image and configuration files that are
used to initialize chassis firmware and configure the interfaces.
Syntax: show boot-config
Command Modes: User-execute and privileged-execute modes.
Privilege Level: General read-only user.
Usage Guidelines: This command lists the files that were used to bring-up the system, the files
to use the next time the system is rebooted, and the backup files to use in the event that the
primary boot files are not available.
The fields in the show boot-config output are described in the table below.
Table B-3 show boot-config Command Field Descriptions
DescriptionField
Slot identifier of the controller card in use. This value is either 1 or 14.slot-id
Version of the software-image used to initialize chassis components.sw-version
Directory name of the system-image used to initialize chassis components.last-image-source
Name of the file used to configure chassis interface cards and set system parameters.last-config-source
Name and directory location of the system-image to use to initialize chassis components the
next time the system reboots.
primary-image-source
Name of the configuration file to use to restore the system configuration the next time the
system reboots. This field is affected by the save running-config command.
primary-config-source
Alternate image directory to use to initialize the system. This file is used if the file specified
in primary-image-source is not available.
secondary-image-source
Alternate configuration file to use to restore the system configuration. This file is used if the
file specified in primary-config-source is not available.
secondary-config-source
Examples:
HP-IB# show boot-config
============================================================================
System Boot Configuration
============================================================================
slot-id : 1
sw-version : HP-IBOS-1.1.3/build255
last-image-source : HP-IBOS-1.1.3/build255
last-config-source : running_config.cfg
Show Commands 135