BIND 9.3.2 Release Notes

NOTE: Ensure that the DNSUPGRADE.PHNE_33766 product or the
DNSUPGRADE.PHNE_34226 product is installed before installing the
DNSUPGRADE.BindUpgrade product. If you have installed the PHNE_33766 or
PHNE_34226 patch or any of its superseding patches, you need not install the
DNSUPGRADE.PHNE_33766 or DNSUPGRADE.PHNE_34226 product.
14. Press the space bar to select the product that you wish to install.
IMPORTANT: Do not install Web release versions of BIND prior to BIND 9.3.2,
after installing the DNSUPGRADE.BindUgrade product.
15. Select Install in the Action menu. The Install Analysis window is displayed.
16. Select OK when the Status field displays a Ready message. The Install window is
displayed.
The BIND 9.3.2 software installation starts. The swinstall command loads the
BIND 9.3.2 files on to the system in approximately 3 to 5 minutes.
17. Select Done when the Status field displays a Completed message.
18. Select File->Exit to exit from the swinstall window.
The named daemon is preconfigured and starts after installation. The swinstall
command installs BIND in the /opt directory.
For more information on configuring and using BIND, see the HP-UX IP Address and
Client Management Services Administrator’s Guide at:
http://www.docs.hp.com/en/netcom.html#Internet%20Services
Verifying the BIND 9.3.2 Installation
To verify whether the BIND 9.3.2 depot is installed successfully on your system, enter
the following command at the HP-UX prompt:
# swlist -l product <depot_name>
If BIND 9.3.2 is installed properly, the following output is displayed:
• On an HP-UX 11i v1 operating system
# Initializing...
# Contacting target "hostname"...
#
# Target: hostname:/
#
BindUpgrade C.9.3.2.7.0 BIND special release upgrade
• On an HP-UX 11i v2 operating system
18 BIND 9.3.2 Release Notes