BIND 9.3.2 Release Notes

NOTE: If you have installed the Web upgrade version of BIND 9.2.0 on an HP-UX
11i v1 system, ensure that you remove the BIND 9.2.0 depot before installing BIND
9.3.2.
Installation Instructions
To install BIND 9.3.2, complete the following steps:
1. Review to ensure that your system meets BIND 9.3.2 installation requirements.
2. Go to the HP Software Depot website at:
http://h20293.www2.hp.com/
3. Use the Search button to browse for BIND. The product catalog page is displayed.
4. Select BIND in the product catalog. The BIND page is displayed.
5. Read the “Overview” and “Installation” pages for BIND.
6. Select the Receive for Free>> option at the bottom right of any of these pages.
7. Select the appropriate release of HP-UX operating system.
8. Enter the registration information. Read and accept the terms and conditions
statements.
9. Click Next>>. The Electronic Delivery Receipt page is displayed.
10. Select the BIND 9.3.2 depot under Download Software.
11. Save the BIND 9.3.2 depot in a local directory, for example, /tmp.
12. To verify that the BIND 9.3.2 depot is downloaded properly in the local directory,
enter the following HP-UX MD5 Secure Checksum command at the HP-UX prompt:
# md5sum <depot_name>
The result of this command must match the fingerprint provided in the Electronic
Delivery Receipt. If the result does not match, download the BIND 9.3.2 depot
again.
NOTE: The HP-UX MD5 Secure Checksum software is not installed by default
on the system. It is available at:
http://h20293.www2.hp.com/
13. To install the BIND 9.3.2 depot, enter the following command at the HP-UX
prompt:# swinstall -s <fully_qualified_depot_source_path>
The swinstall window is displayed.
Installing BIND 9.3.2 17