Installing and Managing HP-UX Virtual Partitions (A.01.01)

Monitor and Shell Commands
Notes on Examples in this Chapter
Chapter 5 73
Notes on Examples in this Chapter
Syntax of Example Commands
The example commands at the UNIX shell level in the following section
use the following syntax:
<shell prompt><command>
where the shell prompt consists of the hostname of the current virtual
partition and the hash sign (#). For example, if we log into winona1 and
run the ls command, the command is shown as:
winona1# ls
If we are logged into winona1 and run the vparboot command with
winona3 as the target virtual partition, the command is shown as:
winona1# vparboot -p winona3
Example Computer
All the examples in this section use the same N-class configuration as in
the installation chapter. See “Example Computer” on page 48.