HP-UX vPars and Integrity VM V6.1.5 Administrator Guide (5900-2295, April 2013)

Table 14 Options to the hpvmcreate Command (continued)
DescriptionOption
Specifies values for dynamic memory setting associated with the guest,
including:
• dynamic_memory_control
• ram_dyn_type
• ram_dyn_min
• ram_dyn_max
• ram_dyn_target_start
• ram_dyn_entitlement=amount
• amr_enable={0|1}
• amr_chunk_size=amount
• sched_preference
• graceful_stop_timeout
For more information about dynamic memory, see Section 11.9 (page 184).
Also specifies values for Online VM Migration:
• migrate_copy_phase_timeout={number of seconds}
• migrate_frozen_phase_timeout={number of seconds}
• migrate_init_phase_timeout={number of seconds}
• migrate_io_quiesce_phase_timeout={number of seconds}
• online_migration={enabled | disabled}
• tunables={name=value[,name=value,...]}
For information about Online VM Migration, see Chapter 12 (page 199)
Specifies arbitrary virtual machine or vPar attributes that control their behavior:
• vm_type={vpar|shared}
• resources_reserved={0|1}
• active_config={0|1}
-x keyword=parameter
Suppresses all resource conflict checks and associated warning messages
(force mode). This option is primarily intended for use by scripts and other
noninteractive applications. Note that you will receive no notification of
potential resource problems for a virtual machine created with the F option.
NOTE: The -F option is deprecated in Integrity VM commands; this option
should be used only at the direction of HP Support.
-F
Verifies the virtual machine configuration and returns warnings or errors, but
does not create the virtual machine.
This option is used to invoke the hpvmcreate command's resource checking
for a virtual machine configuration without actually creating the virtual machine.
If the -s option is not specified, the virtual machine is created even if resource
warnings occur.
-s
Group with administrator or operator privileges over the virtual machine. Enter
the group name for group, and enter either admin or oper.
-g group[:admin | oper]
User with administrator or operator privileges over the virtual machine. Enter
the user name for user, and enter either admin or oper.
-u user[:admin | oper]
7.2 Using the hpvmcreate command 89