HP-UX vPars and Integrity VM V6.1.5 Administrator Guide (5900-2295, April 2013)

3.7 Troubleshooting installation problems
If the installation verification succeed with warnings, report the problem using the procedures
described in Chapter 13 (page 219). Some problems encountered in the process of installing Integrity
VM are described in the following sections.
3.7.1 Error messages during installation
One or more of the following messages might be displayed during Integrity VM installation:
could not write monParams: Device is busy
hpvmnet * already exists
/sbin/init.d/hpvm start ran without running /sbin/init.d/hpvm stop
You can ignore these messages.
3.7.2 Warning during startup if HP SIM is installed
Integrity VM generates a warning during startup if HP SIM is installed, but Integrity VM continues
to start. The HP SIM product consumes memory and CPU resources that would otherwise be
available for running virtual machines. The amount of memory and CPU consumed varies depending
on the specific system configuration. On systems that are already tight on memory or CPU resources,
this might cause virtual machines to fail to start.
3.7 Troubleshooting installation problems 41