HP-UX vPars and Integrity VM V6.1.5 Administrator Guide (5900-2295, April 2013)

/dev/rtape/tape6_BESTn:CONFIG=gdev,EXIST=YES,SHARE=NO,DEVTYPE=ATTACH,SHARE_LUNPATHS=YES:
lunpath3,lunpath6,lunpath5,lunpath4:0x01.0x00.0x03.0x500104f0004732d8
9.1.3.4 Mapping AVIO storage devices on HP-UX guests
This section explains how to map an AVIO storage device on an HP-UX guest to an hpvmstatus
display on the Integrity VSP either at the EFI console or at the HP-UX operating system.
The following example shows the output of hpvmstatus from the Integrity VSP:
# hpvmstatus -P aviotest
[Storage Interface Details]
Guest Physical
Device Adaptor Bus Dev Ftn Tgt Lun Storage Device
======= ========== === === === === === ========= =========================
disk avio_stor 0 2 0 22 0 disk /dev/rdisk/disk7
The following statistics are displayed in this example:
• PciBus = 0
• PciDev = 2
• PciFtn = 0
• Addr (Target Id) = 22 (0x16)
• Lun = 0
Note that Addr (Target Id) is decimal in the hpvmstatus display, and PciFtn and Lun are always
zero (0).
The Integrity VM guest EFI device path encodes PciBus, PciDev, and Addr (Target Id) from the
hpvmstatus display:
PciDev
|
| PCIFtn
PciBus | | Addr(Target Id)
| | | |
V V V V
blk16 : Acpi(PNP0A03,0)/Pci(2|0)/Scsi(Pun16,Lun0)
PciFtn (PCI function) and Lun# are always zero (0). Addr (Target Id) becomes EFI Pun# and is
displayed as a hexidecimal number.
The two methods for mapping an Integrity VM HP-UX 11i v2 guest hardware path or HP-UX 11i
v2 Device Special File (DSF) to an Integrity VSP hpvmstatus display:
1. -e option of the ioscan utility
ioscan -fne displays the HP-UX hardware path/DSF and the EFI device path for the device.
The HP-UX hardware path encodes the following from the hpvmstatus display:
• PciBus
• PciDev
• Addr (Target Id)
Addr (Target Id) is encoded as an HP-UX tgt ID and an HP-UX lun ID in the HP-UX hardware
path.
HP-UX tgt ID and HP-UX lun ID are calculated from Addr (Target Id) in the hpvmstatus display
using the following equations:
HP-UX tgt ID = Addr(Target Id) % 16
HP-UX lun ID = Addr(Target Id) / 16
Note the following example:
# ioscan -fne
PciDev
| PCIFtn
| |(Addr(Target Id) % 16) <-> HP-UX tgt ID
114 Creating virtual storage devices