HP-UX Virtual Partitions Administrator Guide (includes A.05.09) (5900-2188, March 2012)

Note that this process works only using Update-UX and a corresponding Ignite-UX depot; it does
not work by directly using the OE and vPars media. If you wish to install directly from media, you
should use the instructions from any of the following sections:
• “Installing vPars with Ignite-UX on PA-RISC” (page 112)
• “Installing vPars with Ignite-UX on Integrity” (page 114)
• “Installing vPars with Software Distributor ” (page 116)
Overview of the Mixed HP-UX 11i v1/v2 vPars Environment Update Process
This section provides a high-level overview of the process for updating from a vPars A.03.xx
environment to a mixed HP-UX 11i v1/v2 vPars environment. For details and examples of the
update process see “The Update Process for Mixed HP-UX 11i v1/v2 vPars Environments: Step by
Step Details” (page 85).
Figure 10 shows an overview of the update process for migrating an HP-UX 11i v1 vPars
environment to a mixed HP-UX 11i v1/v2 vPars environment. For details see High-Level Description
of the Mixed HP-UX 11i v1/v2 vPars Environment Update Process (page 81) and “The Update
Process for Mixed HP-UX 11i v1/v2 vPars Environments: Step by Step Details” (page 85).
80 Installing, Updating, or Removing vPars and Upgrading Servers with vPars