HP Instant Capacity Version 10.x User Guide HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3 (5900-3361, December 2013)
# icapmanage -a -S sgm.corp.hp.com
Enter the password for root on sgm.corp.hp.com:
icapmanage command failed.
ERROR: The following low-level error occurred:
PGS08001: CIM HTTP or HTTPS connector cannot connect to sgm.corp.hp.com:5989.
Connection failed.
#
sslClientVerificationMode is not set to optional on SGM.
Action: Perform the following commands on AGM:
cimconfig -s sslClientVerificationMode=optional –p
cimserver –s
cimserver
# icapmanage -a -S sgm.corp.hp.com
Enter the password for root on sgm.corp.hp.com:
This operation may take a while to complete. The Group Manager
must contact every member host in each GiCAP group to
update the standby manager data and establish secure communication.
Enter the password for user ID standby_gm which will be created on
all SD2 machines:
icapmanage command failed.
Host sgm.corp.hp.com is not eligible for use as a standby Group Manager.
It is already an active Group Manager.
#
An attempt to configure a valid AGM as SGM fails.
Action: Reconsider another system as SGM.
# icapmanage -t
icapmanage command failed.
CIM_ERR_NOT_SUPPORTED
CIM_ERR_NOT_SUPPORTED: PGS04001: Provider is blocked.
#
The status for HP_GiCAPProviderModule is not OK on AGM.
Action: Execute cimprovider -em HP_GiCAPProviderModule on AGM.
# icapmanage -ticapmanage command failed.
CIM_ERR_NOT_SUPPORTED
CIM_ERR_NOT_SUPPORTED: CIM_ERR_NOT_SUPPORTED: PGS04001: Provider is blocked.
#
The status for HP_GiCAPProviderModule is not "OK" on SGM
Action: Execute cimprovider -em HP_GiCAPProviderModule on SGM.
# icapmanage -t
icapmanage command failed.
HTTP Error (401 Unauthorized).
#
sslClientVerificationMode is not set to optional on SGM.
Action: Perform the following commands on AGM:
cimconfig -s sslClientVerificationMode=optional –p
cimserver –s
cimserver
# icapmanage -t
icapmanage command failed.
PGS08001: CIM HTTP or HTTPS connector cannot connect to sgm.corp.hp.com:5989.
128 Troubleshooting error messages