HP Instant Capacity Version 10.x User Guide HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3 (5900-3361, December 2013)

GiCAP group CloudProd does not exist.
#
Action: Create a group before adding members.
# icapmanage -a -m sd2prod1:sd2prod1oa1.corp.hp.com -g CloudProd
NOTE: sslClientVerificationMode on cloud-gm.corp.hp.com is either disabled
or will be disabled if the CIM Server there restarts. sslClientVerificationMode
must be enabled on cloud-gm.corp.hp.com if GiCAP operations involving it are
to succeed. See the cimconfig(1M) manpage for information on how to enable
sslClientVerificationMode.
Enter the password for the administrator on sd2prod1oa1.corp.hp.com:
Member sd2prod1 added to group CloudProd.
#
sslClientVerificationMode must be "optional" on AGM.
Action: Perform the following commands on AGM:
cimconfig -s sslClientVerificationMode=optional –p
cimserver –s
cimserver
# icapmanage -a -m sd2prod1:sd2prod1oa1.corp.hp.com -g CloudProd
Enter the password for the administrator on sd2prod1oa1.corp.hp.com:
Enter the password for active_gm on sd2prod1oa1.corp.hp.com:
icapmanage command failed.
sd2prod1 is already a member of a group managed by 192.168.10.10.
#
sd2prod1oa1> icapstatus
..(snip)..
Member sd2prod1 in GiCAP group CloudProd1
Active Group Manager: 192.168.10.10
Standby Group Manager: 192.169.15.4
Borrowed core usage rights: 0
Borrowed memory usage rights: 0.0 GB
As long as the member removal is not performed on the old AGM (192.168.10.10), the member
addition attempt does not work on the new AGM.
nl
Action: If the old AGM is still present, add the member again and remove it from the group. If this
is not possible, please contact HP Response Center to make a non-GiCAP group member codeword
request.
# icapmanage -a -m sd2prod1:sd2prod1oa1.corp.hp.com -g CloudProd
Enter the password for the administrator on sd2prod1oa1.corp.hp.com:
Enter the password for active_gm on sd2prod1oa1.corp.hp.com:
icapmanage command failed.
The member candidate system already has the maxmimum number of CA certificates installed.
Please make space for a CA certificate and try again.
The maximum number of CA certificates is 12.
Action: Check the installed CA certificates using show ca certificate. Remove the unnecessary
CA certificates using remove ca certificate and reduce the total number to 11 or less.
# icapmanage -r -m sd2prod1
icapmanage command failed.
Cannot remove member sd2prod1oa1.corp.hp.com (serial number) from group CloudProd
as it has loaned core usage rights to other members of the group.
#
Action: Before removing a member with loaned core usage rights, it is required to have sufficient
resources elsewhere in the GiCAP group to cover the loan.
# icapmanage -r -m sd2prod1
icapmanage command failed.
126 Troubleshooting error messages