HP Instant Capacity Version 10.x Release Notes (5900-1580, March 2011)

NOTE: On HP-UX 11i v2 systems, updated firmware might be required by the nPar or Virtual
Partition software, as documented for these products.
Required Patches for HP-UX 11i v2
The following patches are required for Instant Capacity version 10.x on HP-UX 11i v2:
• PHKL_33752: S700_800 11.23 Itanium 2 Processor speed reporting patch
required only for IA systems
• PHCO_34721: killall(1M) patch
• PHKL_35174: _CS_PARTITION_IDENT patch required for GiCAP on rx8640 and rx7640
systems
IMPORTANT: For the most recent required patches, see the Instant Capacity Installation page on
the HP Software Depot (search for “B9073BA”):
http://www.hp.com/go/softwaredepot
HP-UX 11i v3 Requirements and Dependent Products
The following software is required for Instant Capacity version 10.x on HP-UX 11i v3:
• HP-UX 11i v3
• iCAP software bundle B9073BA (version10.x) — Installed automatically when the HP-UX 11i
v3 Operating Environment (OE) is installed, or download the most recent version from the HP
Software Depot at http://www.hp.com/go/softwaredepot.
• The kernel configuration must include the diag2 module.
• WBEMSvcs bundle (version A.02.05 or higher)
• nParProvider bundle (version B.31.01.07.01 or higher, available from the OE media)
• If you have a virtual partitioned environment, the Virtual Partitions (vPars) software (bundle
T1335BC) must be version A.05.01 or higher. vPars is available separately and is not included
with the OE.
• (GiCAP only) The CIM Server configuration property sslClientVerificationMode must be set to
a value of “optional” on all GiCAP Group Managers and on all OS instances of all member
systems. (The CIM Server may need to be restarted if the property was not previously set to
this value.) For details on setting sslClientVerificationMode, see “Upgrading Version 8.x Groups
to Version 9.x or Later” (page 27). Note that communication between the managers and
members of groups is established using SSL certificates that are supplied by the GiCAP software.
Required Patches for HP-UX 11i v3
For Instant Capacity Version 10.00 and later, on HP–UX 11i v3 HP Integrity systems, patch
PHCO_40927 must be installed. This is a co-requisite.
OpenVMS Version 8.4 Requirements
The following software is required for Instant Capacity version 9.x (or later) on OpenVMS Version
8.4:
• HP OpenVMS Version 8.4 for Integrity Servers or later
• iCAP software bundle BA484AA (version 9.x or later) — Included with OpenVMS Version 8.4
and automatically installed on relevant systems when Version 8.4 is initially installed.
Software Requirements 25