HP Instant Capacity User's Guide for Versions 8.x

Instant Capacity Software Validation
On HP-UX Systems
The Instant Capacity software (HP-UX product B9073BA) is installed by HP manufacturing on
instantly ignited HP-UX systems. The Instant Capacity software can also be installed by an HP
service representative on existing (supported) HP-UX enterprise servers as an add-on.
NOTE: The Instant Capacity software is automatically installed when the HP-UX 11i v3, 11i
v2, or 11i v1 Operating Environment (OE) is installed.
To verify the Instant Capacity software is installed on your system, execute the following HP-UX
command:
/usr/sbin/swlist -l product iCOD
You should see output similar to:
iCOD B.11.23.08.03 HP-UX iCOD Instant Capacity
To ensure the Instant Capacity software installation has not been corrupted, execute the following
HP-UX command:
/usr/sbin/swverify iCOD
You should see Verification succeeded. in the output of the swverify command.
On OpenVMS Systems
On OpenVMS systems, the Instant Capacity software is automatically installed on partitionable
systems when the OpenVMS V8.3 or later operating system is installed. You should not need to
install iCAP software separately on OpenVMS systems. On-site iCAP installation by an HP
service representative after the initial installation of OpenVMS 8.3 is not an option for OpenVMS
systems.
On OpenVMS systems, run the following commands to verify the Instant Capacity software is
installed and configured:
$ @sys$manager:ICAP$CLI_UTILS.COM CONFIG_CHECK
$ show log ICAP$CONFIGURED
"ICAP$CONFIGURED" = "TRUE" (LNM$JOB_nnnnnnnn)
Instant Capacity Software Validation 43