HP Instant Capacity support 10.x Release Notes (762795-002, June 2014)

iCAP commands
All the iCAP commands can be executed from both operating system and OA command line
interface. The only difference between the two methods of execution is as follows:
• While executing icapmodify command from OS, the partition ID parameter must not be
mentioned, the current partition ID is taken as default ID.
• While executing icapmodify command from OA, the partition ID parameter must be
mentioned explicitly.
All the commands continue to work from OA command line interface. For more information about
commands, see Chapter titled iCAP HP-UX Manpages for HP Integrity Superdome 2 with Dynamic
Cores in the HP Instant Capacity Version 10.x User Guide.
TiCAP
For more information about TiCAP, see Section titled HP Integrity Superdome 2 with Dynamic Cores
in the Chapter titled Using iCAP on HP Integrity Superdome 2 in the HP Instant Capacity Version
10.x User Guide.
GiCAP
NOTE: In legacy machines, TiCAP usage information used to be logged in the partition but in
HP Integrity Superdome 2 system this TiCAP usage information is logged in the OA syslog, which
is not normally accessible by the user.
Setting up GiCAP environment
For more information about GiCAP, see Section titled HP Integrity Superdome 2 with Dynamic
Cores in the Chapter titled Using iCAP on HP Integrity Superdome 2 in the HP Instant Capacity
Version 10.x User Guide.
8 HP Instant Capacity support 10.x Release Notes