HP Instant Capacity support 10.x Release Notes (762795-002, June 2014)

Strictly correct email address must be set with icapmodify -c
From the complex firmware bundle 3.6.48, an email address with an FQDN must be specified
using the format icapmodify -c <contact_email_address>. HP recommends to set any
dummy email address, if you want to remove the configured email address and do not want to
disable the alert mail functionality.
Re-adding members may fail after GM OS SSL certificates are renewed
If SSL certificates are renewed with GiCAP_OA_keygen on GMs after removing members for any
reason, you must restart the member OAs before re-adding the members. If multiple OAs are
specified for a member, both OAs must be restarted, without which the member additions will not
work.
Performance improvement in 10.08.01.07 release
The performance changes that are part of the 10.08.01.07 release are targeted at GMs running
on HP Integrity servers. As of the 10.08.01.07 release, they are partially beneficial to users who
have GM on HP 9000 servers. It is recommended that users upgrade their GM to HP Integrity
systems or wait till the same is available for HP 9000 servers too.
Known problems
Error generated while adding members to a GiCAP group
While adding a member to a GiCAP group, if a time difference exists between the AGM and the
member, the following error message is displayed:
Error: Certificate is not yet valid: the notBefore date is after the current time.
It is also possible that the member time might have lagged AGM time during the certificate
regeneration on AGM. HP recommends the following steps to resolve the issue:
1. Synchronize the timing between the AGM and the member
2. Regenerate the certificate on AGM
3. Restart the OA member
4. Readd the same OA member
Error generated during partition reboot
In HP Integrity Superdome 2 with Dynamic Cores, when partitions are managed with TiCAP turned
ON, and if one or more of the partitions goes down, the RTUs associated with the partitions are
freed up by iCAP and are available for use in other partitions. This may lead to errors while booting
the partitions that are down.
This problem can be solved by using TiCAP to boot up the partition. Use the command icapmodify
–T on to turn on the TiCAP pre-authorization flag on OA. See the TiCAP pre-authorization usage
matrix, in the HP Integrity Superdome 2 with dynamic cores chapter in HP Instant Capacity 10.x
User Guide.
Command timeout
When a command timeout occurs while executing icapmodify -a or -d,
nl
there can be a mismatch between Intended Active and Actual Active values. You must execute
icapmodify -s to correct this mismatch.
Known problems 11