HP Instant Capacity release notes for Version 10.x, August 2010 (T1428-90081)

Changes in Asset Reporting
Asset reporting is disabled by default on new installations of Instant Capacity. Asset reporting
will remain at the previous setting for reinstalls and upgrades. Asset reporting can be enabled
with the command icapnotify -a on.
GiCAP member asset reports sent to the HP portal will reflect the correct inventory. In previous
versions, an audit snapshot was not adjusted for GiCAP loan/borrow counts and the reported
inventory for the complex would not always match the portal inventory.
Cell Online Activate and Deactivate
iCAP version 8.02 included support for the cell online activate and deactivate feature introduced
in HP-UX 11i v3, which allows cells to be taken offline and activated online without requiring a
reboot.
Improvements in icapstatus output
Several changes were made to the icapstatus output. These changes included the addition of
a datestamp showing the date and time the command was issued, and a new symbol, “#” in the
display. Refer to the Instant Capacity user’s guide for versions 8.x and the icapstatus manpage
for details on the icapstatus output.
Add-On Codeword Fixed
In previous releases, when applying an Add-On codeword to an active partition, the Intended
Active cores for that partition was incorrectly set to the total number of configured cores on active
cells for that partition. This is fixed.
Other Changes
Fixed a problem where an icapmodify -d or an icapmodify -s operation would erroneously
issue an exit code of success even if the operation was only partially satisfied. With this release,
a partially satisfied request will correctly exit with an error code.
Error messages from nPar Provider have been standardized and now include an “NPAR” prefix.
ssh can now be configured with a banner. In previous releases, this would produce errors when
managing a GiCAP group (icapmanage error).
Changes in Version 8.1 (OpenVMS)
Implementation of Global Instant Capacity (GiCAP)
GiCAP is fully functional in iCAP version 8.1 on OpenVMS systems. The Group Manager must
be an HP-UX system running Instant Capacity software version 8.01.01 or later.
26 Major Changes, New Features, and Requirements of Instant Capacity Version 10.x