HP Instant Capacity for HP Integrity Superdome 2 Servers

List codewords

The link provides a list of all the codewords that have been created for a specified system serial

number. It also indicates if no codewords have been created. However, this link will not work with

HP Superdome 2 serial numbers as there are no codewords involved in this release. The functionality

will be available at a later release.

Temporarily activating and deactivating HP iCAP cores with

HP TiCAP or HP IAC

After purchasing and installing iCAP cores, five processing days of HP IAC are provided for each

core acquired. To access this capacity, the same process to acquire and use TiCAP is followed.

Before the workload demand for additional cores occurs, purchase and install temporary capacity on

the system. Each TiCAP enables any number of iCAP cores for a total of 30 processing days. When

additional cores are required, the cores can be immediately activated.

Figure 7: Process to temporarily activate iCAP cores

Note: IAC and TiCAP can be used on any partition in a server or GiCAP group but the tracking and

setup is done separately on each partition.

Install iCAP blades/

processors

Order TiCAP

Use iCAP commands to

distribute the IAC/TiCAP to the

appropriate partitions and

then activate IAC/TiCAP on

each iCAP core as necessary

When additional

processing capacity is

needed

Instantly activate cores

with TiCAP

(iCAPcommands)

When additional

processing capacity is no

longer needed

Deactivate TiCAP to

deactivate iCAP cores

(iCAP commands)