HP-UX 11i v3 Read Before Installing or Updating, September 2007 (Update 1 Release)

28
Cannot Find Boot Device
If you install the HP-UX 11i v3 media or a media image using an
iLo-2 vMedia USB DVD device, it may be necessary to
interactively indicate the device after boot to continue with the
installation. In some cases the USB Mass Storage driver may not
by able to detect the device as the boot source due to a late
simulated device attach. If this occurs Ignite-UX will display the
following warning:
WARNING: Could not find Q_BOOT device. Cannot determine
what the boot device was.
WARNING: Could not find source device in ioscan output.
You must select from the list of devices below to use for
the source device:
...
(a listing of the I/O config)
..
Enter the index corresponding to the device to use as the
installation source, 'r' to rescan, or 'q' to reboot:
NOTICE: USB device attached.
Identification String:
Devices/MassStorage-SCSI/USB/BulkOnly/hp/Unknown/0_1
<2.310.3.150.1008.4902.1>
NOTICE: USB device attached.Identification String:
Devices/ScsiControllerAdaptor/USB/BulkOnly/hp/Unknown
<2.1000.3.150.1008.4902>