HP-UX 11i v3 Installation and Update Guide, September 2011

• Ignite-UX will consider available root disk space and adjust sizes to be larger.
• The Ignite-UX UI File System tab can be used to set specific sizes.
CAUTION:
If the default size for the /stand partition is too small for your environment, do not use the
lvextend command to increase the size of the /stand partition; doing so might render your
system unbootable. Instead, use a Dynamic Root Disk (DRD) clone to create an inactive copy of
the system on which /stand can be extended, or use Ignite-UX recovery to create a recovery
image and resize the /stand partition.
To use a DRD clone to extend /stand on an LVM-managed system, see the white paper “Dynamic
Root Disk: Quick Start and Best Practices” (http://www.hp.com/go/drd-docs). Further information
on DRD is available at the DRD website: http://www.hp.com/go/drd. See also “Reducing downtime
using Dynamic Root Disk” (page 29).
You can boot from an Ignite-UX recovery image and resize /stand as you recover the system.
For help creating a recovery image, see the Ignite-UX Administration Guide available at the Ignite-UX
website: http://www.hp.com/go/ignite-ux.
Table 3 Minimum disk space recommendations
Recommended spacePartition/file system
1 GB/
1.5 GB/stand
512MB + swap size/var
4 GB/usr
500 MB/tmp
7 GB/opt
Depends on application and user requirements. It might
make sense to mount a separate file system at /home.
1
/home
1x - 2x memory size for most systems./swap
500 MBItanium EFI System (Boot) Partition
400 MBItanium HP Service Partition
1 In other words, you might want to put /home on a separate disk and separate volume group. This makes future recovery
and upgrade operations easier. By default, /home is created as a separate file system; however, it is part of the root
volume group.
Disk space requirements for an update
To ensure a successful update to HP-UX 11i v3, make sure that you have at least as much disk
space allocated to the partition/file system listed in Table 3 (page 12) and that each partition/file
system (most importantly, /usr, /opt, and /var) has at least 10-20 percent free space to allow for
any growth.
Note the update process will check the disk space requirements. If the system doesn't meet the
requirements, the update will not proceed.
Verifying supported network drivers, mass storage drivers, I/O cards, and
storage devices
Before installing HP-UX 11i v3, make sure that the drivers, I/O cards, and storage devices on your
system are supported.
12 Assessing your system and meeting system requirements