HP-UX 11i v3 Installation and Update Guide, September 2009 (Update 5 Release)

The OE-Selection tab displays the list of OEs to which you can update. The OE that
matches the one currently installed on your system is automatically selected. You may
choose a different OE by selecting it (which will automatically deselect the other).
Figure 6-4 OE Selection Tab
With this screen, you can accomplish two tasks: 1) review the contents of an OE you
are considering for update, and 2) make the actual OE selection. With the next screen
(in Step 4), you will be able to select the individual software bundles.
a. The OE software is divided into three install types: required, recommended, and
optional. If you are not familiar with the special meanings of these terms, see their
definitions in “HP-UX 11i v3 Operating Environment install/update structure”
(page 119). In addition, the software is separated into several product categories.
Again, see “HP-UX 11i v3 Operating Environment install/update structure”
(page 119) for more information.
On this tab you can review the software contents included within the OE:
Highlight the category you would like to review and press Enter to expand and
view its contents.
b. When you are ready to select the OE to which you want to update, navigate to the
OE listing and press the spacebar to select it. Then enter n (next) to confirm your
selection and proceed to the SW-Selection tab.
The system displays the message: Working...Loading *temporary* update
tools that do not affect the running system and will be
removed when the OE update is finished.
66 Updating to HP-UX 11i v3