HP-UX 11i v3 Installation and Update Guide, September 2008 (Update 3 Release)

Recommended software product category to select or deselect all recommended
items.
CAUTION: HP recommends that you do not deselect recommended software
bundles or remove them from your system unless you know for certain that the
software contained in these bundles is not required for your operating environment.
In addition, software may have unstated dependencies. Deselecting software may
prevent products with dependencies on the software you deselected from
functioning correctly.
For more information about the products and software bundles included in the
OEs, see Appendix D (page 131).
7. Use the System tab to configure system parameters such as security levels, host
name, IP address, root password, and the time zone. You must set the appropriate
security setting for your system at this time; you can choose to set the other system
parameters now or at the first boot of your system, using set_parms(1M).
To set the appropriate security settings for your system, do the following:
• Navigate to the System tab and select Security Choices.
The four security levels appear. By default, Sec00Tools is selected.
• Select the appropriate security setting for your system.
• Select OK.
For more information about setting appropriate security levels, see “Security
Considerations” (page 37).
8. Use the File System tab to perform a variety of filesystem and disk-configuration
tasks: for example, resizing file systems and adding and removing disks. You can
also re-configure the volume structure and associated file system mount points.
The File System tab will differ in appearance, depending on whether you previously
selected LVM or whole disk on the Basic tab.
Please note that renaming or changing any disk file system structure on which
Ignite-UX installs file system content causes the old file system on that disk to be
lost. For more information on using the File System tab, refer to the Ignite-UX
Administration Guide (http://docs.hp.com/en/oshpux11iv3.html#Ignite-UX).
9. Use the Show Summary button to view a summary of how your system will be
configured. If you see any problems, or want to change any of your selections,
back up to the appropriate step, and make the needed changes; otherwise select
Go! (at the bottom of the screen) to initiate the installation. Ignite-UX executes a
pre-installation consistency check to identify any errors that must be corrected
before the installation can proceed.
10. The system typically displays the Confirmation Dialog box that lists errors,
warnings and notes for the configuration settings. Review any errors, warnings,
Cold-installing HP-UX 11i v3 75