HP-UX 11i v3 Installation and Update Guide, September 2008 (Update 3 Release)

Table A-1 Known Install and Update Problems (continued)
Description/ActionProblem
Upon reboot of your HP-UX 11i v3 system, the following warning
messages may appear in the /etc/rc.log file:
*Finish containment subsystem configuration Output
from "/sbin/rc2.d/S480sec_late_init start":
setfilexsec: warning: Ignored the entry for file
"/opt/ids/lbin/idssysdsp":
No such file or directory setfilexsec: warning:
Ignored the entry for file "/opt/ids/lbin/idscor":
No such file or directory setfilexsec: warning:
Ignored the entry for file "/opt/ids/bin/idsagent":
No such file or directory setfilexsec: warning:
Ignored the entry for file
"/opt/ids/lbin/updaterc":
No such file or directory ERROR CODE 1
"/sbin/rc2.d/S480sec_late_init start" FAILED
What To Do
You can safely ignore these warning messages as these messages do
not affect the functionality of HIDS or other products installed on
the system. However, these warning messages may continue to
appear in /etc/rc.log file upon every reboot of the system when
the product is installed and then later removed. If you want to stop
receiving these warning messages, execute the following set of
commands to clear entries related to HIDS from the containment
product's configuration file ( /etc/priv-apps/all-apps ):
/usr/sbin/setfilexsec -D /opt/ids/lbin/idssysdsp
/usr/sbin/setfilexsec -D /opt/ids/lbin/idscor
/usr/sbin/setfilexsec -D /opt/ids/bin/idsagent
/usr/sbin/setfilexsec -D /opt/ids/lbin/updaterc
Warning Messages on Reboot of
HP-UX 11i v3 System
Configuring a vPar with a low amount of base memory can result
in system hang or lead to slow system performance.
What To Do
Configure vPars with enough base memory as per the below
guidelines:
• If there is 1 GB to 8 GB total memory assigned to the Virtual
Partition: make sure the minimum base memory is 1/2 of total
memory.
• If there is 8 GB to 16 GB total memory assigned to the Virtual
Partition: make sure the minimum base memory is 4 GB.
• If there is over 16 GB total memory assigned to the Virtual
Partition: make sure the minimum base memory is 1/4 of the total
memory.
Configuring vPar with Low Base
Memory Results in System Hang
or Slow Performance
Known Install and Update Problems 115