HP-UX 11i v3 Installation and Update Guide, September 2008 (Update 3 Release)

Table A-1 Known Install and Update Problems (continued)
Description/ActionProblem
When OnLineJFS 5.0 (B3929FB) is selected during an update from
11i v2 OnlineJFS 4.1 to 11i v3 with OnlineJFS 5.0 (B3929FB), the
following selection time warning from update-ux may be seen:
WARNING: The following was found while selecting
software:
- There are new revisions of SW available in the
source that would update SW already installed on
the system. The newer revisions are not selected
for installation. This could leave the incompatible
old revision of SW on the system. The affected SW
is:
- OnlineJFS.VXFS41-AD-RN,r=B.11.31 replaces
OnlineJFS01.VXFS41-AD-RN,r=4.1.004
What To Do
This warning can be safely ignored. The update will complete
successfully despite this warning. For complete installation
instructions, see also “VxVM and VxFS Installation with Update-UX”
(page 128).
Warning Message During Update
from HP-UX 11i v2 with
OnlineJFS 4.1 to HP-UX 11i v3
with OnlineJFS 5.0
Updating from the HP-UX 11i v2 release to the HP-UX 11i v3 release
may cause the following error to appear in the swagent.log:
cp: cannot access /.secure/etc/*: No such file or
directory
What To Do
You can safely ignore this message.
Cannot Access /.secure/etc/* Error
Message
When updating your system to HP-UX 11i v3, you may encounter
the following warning message in the /var/adm/sw/swagent.log
file:
ln: Warning! dld.sl.orig and dld.sl are identical
What To Do
You can safely ignore this message. Install patch PHSS_37493 to fix
this problem. For availability of this patch, please check the HP IT
Resource Center site: http://itrc.hp.com
Error Message When Updating to
HP-UX 11i v3
Known Install and Update Problems 113