HP-UX 11i v3 Installation and Update Guide, September 2007 (Update 1 Release)

9. On the Security Choices screen, select the appropriate security setting for your
system based on the information in the section called, “Security Considerations”
(page 41). Please note that four security levels are displayed. By default,
Sec00Tools is selected.
Press Next to accept your selection and proceed to the Pre-Install Disk Information
screen.
10. On the Pre-Install Disk Information screen, identify which disks will be
overwritten during the install process. If you see a disk in the list that you do not
want included, back up to the root disk selection and choose another disk;
otherwise, press Next to proceed to the Pre-Install Check Information screen.
11. On the Pre-Install Check Information screen, review any errors, warnings, or
notes. Warnings are simply informational. If any errors are displayed, they will
need to be resolved before you can continue the installation.
Press Next to proceed to the System Summary screen.
12. On the System Summary screen, tab to Show Summary and press Enter to to
view a summary of how your system will be configured. If you see any problems,
or want to change any of your selections, back up to the appropriate step, and
make the needed changes; otherwise select Finish (at the bottom of the screen) to
begin the cold-install process. You can Cancel at this time. If you cancel, you can
start again.
80 Cold-Installing HP-UX 11i v3 From Media