HP-UX 11i v3 Installation and Update Guide, September 2007 (Update 1 Release)

NOTE: If you select VxVM or LVM, the root disk cannot be moved to another
SCSI bus or address that results in a change in the hardware path to the device. If
it is moved, you may not be able to boot safely from it. This is similar to the
limitation present in LVM.
6. On the Root Disk/Volume Group Disks screen, s pecify how many disks you
want placed into the root volume group. If you have more than one disk, you may
select Yes to choose the Striping option. Please note that if you need to select which
disks to use, you must cancel the Guided Installation and use the Advanced
Installation interface.
Press Next to accept your selection and proceed to the Languages screen.
7. On the Languages screen, make sure HPUXLocales(OE) is marked Yes. In
addition, make sure the default language shown on this screen is the language
you wish to install. Press Enter to view the choices.
The locale settings that were previously in HP-UX 11i v2 and located in the CDE
language bundle are now located in the HPUXLocales bundle. The HPUXLocales
bundle contains internationalization support for many languages. This support
includes date and time formats, currency, sorting methods, and so on.
Press Next to accept your selection and proceed to the Additional Software.
NOTE: CDE is an optional product in HP-UX 11i v3. If you require it, you must
explicitly select the CDE bundle (CDE-XXX). This applies if you need dtterm,
which is located in CDE. For some localization situations, dtterm is required,
therefore CDE must be selected. CDE is listed in Table C-3: “Optional Software”,
in Appendix C (page 135).
8. On the Additional Softwarescreen, you can deselect the software bundles that
are recommended and select optional software not installed by default. Browse
the product list, marking your selections, then press Next to accept your selections
and proceed to the Security Choices screen.
HP-UX 11i v3 offers several product categories from which you can select additional
software. In addition, each product category contains software components that
are marked as required, recommended, or optional software components. See “Task
4: Selecting and Deselecting Software Bundles ” (page 81) for more information
on these product categories and required, recommended, and optional software
components.
HP recommends that you do not deselect recommended bundles or remove them
from your system unless you know for certain that the software contained in these
bundles are not required for your operating environment.
Cold-installing HP-UX 11i v3 79