HP-UX 11i v3 Installation and Update Guide, September 2007 (Update 1 Release)

Using the Firmware Selection Menu to Select the Primary HP-UX Console
1. Decide what console you want to use.
Depending on your system configuration, HP-UX can use one of the following
devices as your system console:
• System Serial Port
• Management Processor (MP) Serial Port (if present)
• VGA device (if present)
2. Using the EFI menus, do the following:
• Select Boot option maintenance from the main Boot Manager Menu.
• Select Select Active Console Output Devices.
• Select the correct output device and deselect others. On the HP Integrity rx2600
and the HP Integrity rx5670 systems, the Select Active Console Output
Devices menu looks like this:
EFI Boot Maintenance Manager ver 1.10 [14.57]
Select the Console Output Device(s)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(PcAnsi)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(VtUtf8)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(PcAnsi)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(VtUtf8)
* Acpi(HWP0002,700)/Pci(2|0)
Acpi(HWP0003,400)/Pci(0|0)
Save Settings to NVRAM
Exit
56 Preparing to Cold-Install or Update to HP-UX 11i v3