HP-UX 11i v3 Installation and Update Guide, September 2007 (Update 1 Release)

Supported Network Drivers, Mass Storage Drivers, I/O Cards, and Storage
Devices
Before installing HP-UX 11i v3, make sure that the drivers, I/O cards, and storage
devices on your system are supported.
You can run the msv2v3check script to validate whether the drivers, mass storage
I/O cards, and mass storage devices installed on your system are supported on HP-UX
11i v3. This script will report if any unsupported drivers, mass storage I/O cards, and
mass storage devices are found on your system.
This script will also check the minimum firmware versions required for these cards or
devices on your system to run properly on HP-UX 11i v3. You can retrieve the
msv2v3check script from the HP software depot at:
http://www.hp.com/go/softwaredepot
For a list of supported and unsupported HP-UX I/O cards and mass storage devices,
refer to the HP-UX Supported I/O Cards Matrix and the HP-UX Supported Mass Storage
Devices Matrix at the HP Technical Documentation Web site:
http://docs.hp.com
For more details on the msv2v3check script, refer to the white paper called, HP-UX
11i v2 to 11i v3 Mass Storage Stack Update Guide available at:
http://docs.hp.com/en/netsys.html#Storage%20Area%20Management
HP StorageWorks Compatibility with HP-UX 11i v3
For up-to-date status and recommended firmware versions for HP StorageWorks
components supported with HP-UX 11i v3, please refer to the HP-UX 11i v3 and HP
StorageWorks Compatibility section at:
http://h18006.www1.hp.com/storage/hpuxconnectivitymatrix.html
Third Party (non-HP) Storage Compatibility with HP-UX 11i v3
For an up-to-date list of third-party storage devices which have completed
interoperability validation under the guidance of HP and have been qualified as
interoperable with HP-UX 11i v3, please refer to the following web site:
Supported Network Drivers, Mass Storage Drivers, I/O Cards, and Storage Devices 27